![]() ![]() ![]() BlackHole setup and configuration will only allow One Transcriber to capture the Output Audio data in real time in the so-called “Loopback Mode”, but it’s totally independent (actually in Windows, this feature is automatically embedded in the Operative System, while on MacOS the same Loopback feature is only available by using a tool like BlackHole or others – For example, you can also use SoundFlower as alternative to BlackHole in exactly the same manner and setup). Please note that One Transcriber can be installed even before or without BlackHole at all. Download from here (still you just need to be registered). Here we’re ready to launch One Transcriber. Selet the Multi-Output Device in the Audio selection on the Top bar. Don’t worry about the icon becoming like disabled, your audio will properly work seamlessly. Last step, go on the Audio icon, in the top bar, and select the Multi-Output Device. Set the Mutl-Output Device including the Built-In Output and the BlackHole 2ch virtual device In anycase the Sample Rate should preferrably be at 48,0 kHz. Now, still within the Audio MIDI Setup, go to “Multi-Output Device”, and set the check box for both “Built-in Output” and “BlackHole 2ch”. IMPORTANT! There’s a small trick to fully enable BlackHole in the Audio MIDI Setup: put the Value level of “Master” bar to 0 (actually -64) and then immediately back to the maximum value (1): First, move the bar of Master level to 0 Second, immediately back to max value (1,0) In you MacOS, go to “Applications > Ultilities > Audio MIDI Setup” and open it: the list of all Input and Output audio devices will be shown, as well as the new “BlackHole 2ch” virtual device: pkg and follow the quick steps to install and configure: Blackhole Installation You can download BlackHole directly from One Transcriber Download page here (you must be registered). Install and configure BlackHole beforehandįirst, you need to download and install “Blackhole”, that is a powerful OpenSource software for MacOS that manages Audio loopback and streaming across input/output devices (very similar to the old and historical “SoundFlower”, but more easy to install and configure). Now we have Master being sent to Blackhole 16ch loopback device, which we can route to our other applications like OBS, while monitoring it in Live, and having our click track and other Cue Out being monitored.1. ![]() In", "3/4 Loopback", click the little headphone button on the audio track you just set up. Create a new audio track, mute it, set Audio To "Sends Only", set Monitor to "In", set Audio From to "Ext.Click the Solo/Cue toggle in the master channel to reveal Cue buttons for each track. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |